8
9
9
10. REMOVING THE LINE FLOW FAN
(1) Remove the terminal block cover.
(2) Remove the front panel. (See Photo 1)
() Remove the electrical box. (See Photo 8)
() Remove the nozzle assembly. (See Photo 7)
() Remove the fan motor. (See Photo 9)
(6) Remove the pipe fixture with 2 screws. (See Photo 12)
(7) Remove the left/right screws of the heat exchanger and
pull the left-hand side up.
(8) Remove the 2 screws by sliding it toward you remove the
fixture (fixing bearing).
w
When the fan is hard to remove, remove the fan motor
first.
w
When resetting the fan to the fan motor, locate and fix the
shaft after installing the fan.
(Photo 11)
Heat exchanger
Set screws
Fixture (fixing bearing)
11. REMOVING THE HEAT EXCHANGER
(1) Remove the terminal block cover.
(2) Remove the front panel. (See Photo 1)
() Remove the electrical box. (See Photo 8)
() Remove the corner box.
() Remove the nozzle assembly. (See Photo 7)
(6) Remove the 2 screws and the pipe fixture.
(7) Remove the 2 screws and heat exchanger.
(Photo 12)
Heat exchanger
Set screw
Pipe fixture
Set screws
(Photo 9)
9. REMOVING THE FAN MOTOR
(1) Remove the terminal block cover.
(2) Remove the front panel. (See Photo 1)
() Remove the electrical box. (See Photo 8)
() Remove the nozzle assembly. (See Photo 7)
() Remove the fan motor leg fixing screws.
(6) Unscrew the set screws using by alankey and remove it by
sliding the fan motor to right.
(7) Remove the screws and remove the motor cover from the
fan motor leg.
(Photo 10)
Screws
Set
screw
Fan motor
Motor cover
Motor leg
12. REMOVING ELECTRICAL HEATER (PKH-1.6/2GKLH only)
(1) Remove the terminal block cover.
(2) Disconnect the connector <yellow> for the wireless remote
controller.
() Remove the front panel. (See Photo 1)
() Remove the electrical box. (See Photo 8)
() Remove the nozzle assembly. (See Photo 7)
(6) Remove the heat exchanger. (See Photo 12)
(7) Remove the 2 screws and electrical heater.
Set screws
Electrical heater
Fan motor
Motor cover
(Photo 13)
OPERATION PROCEDURE
PHOTOS & ILLUSTRATION
OC229A
