Mitsubishi LE-40MTA-E, Instruction Manual

Page: 43 / 58

39
8.5 Varies new reel torque
• When the system changes to the new reel in the two-reel op-
eration, the external input of 0 to 5V sets the control output
from 0 to 100%.
• Connect this input to the terminal A12 or A13.
This input is valid if it is greater than the internal new reel pre-
set value. See the notes on the page 37.
• In the two-reel operation, the system performs this input des-
ignation and gives the switch-over signal from reel change
input MC2.
• To enter the new reel torque by the external analog input, use the "A12" or "A13” setting screen within
"SWITCH" on the initial setting screen or the engineer screen.
8.6 Enters external tension data
• Signals of 0 to 5V (zero to full scale tension) from the auxil-
iary tension detector are entered to the terminal A12 or A13
through LM-10TA type tension amplifier or similar device.
• This input is compared with the signal detected value by the
tension detector which is connected directly to the LE-
40MTA-E. The automatic control is carried out using the
greater value.
• If Mitsubishi tension detector is not used, carry out zero ad-
justment according to the instruction on page 10. In this
case, short-circuit the terminals GRR and WHR and termi-
nals GHL and WHL.
• To enter the external tension signal by the external analog input, use the "A12" or "A13” setting screen
within "SWITCH" on the initial setting screen or the engineer screen.
• The 4-digit, 7-segment display shows the tension for confirmation.
AIC
100k
Ω
+5V
AI2
AI3
New reel
torque
1. Connection
2. Setting
A 2 S E L E C T A I 2 A N A L O G I N P U T
D I A . : S T A L L : „ N E W R . : T A P E R : T N S N .
I
Select "NEW R."
T N S N .
→
# # # # N
N W R . S E T E X T .
S E T
→
# # # %
E
„ „ „ „ „ „ „ „ „ „ „ „ „ „ „ „
When the external analog input is valid, message "EXT."
appears on the "new reel set" screen as shown below. If "EXT."
is gone, the key setting is greater and is therefore valid.
3. Display
AIC
100k
Ω
+5V
AI2
AI3
External
tension
signal
1. Connection
2. Setting
A 2 S E L E C T A I 2 A N A L O G I N P U T
D I A . : S T A L L : N E W R . : T A P E R : „ T N S N .
I
Select "TNSN."
3. Display