Mitsubishi Lancer Sportback, Owner'S Manual, Page: 145 / 433

The buzzer stops when the driver’s door is
closed. (The warning is also displayed on the
multi-information display.)
The buzzer stops in the following manner.
• Turn the lamp switch to the “OFF” posi-
tion.
• Close the driver’s door.
l When the engine was started using the key-
less operation function, if the driver’s door is
opened and the ignition switch is in the
“LOCK” position, the lamp monitor buzzer
sounds at a high pitch intermittently.
The buzzer stops when the driver’s door is
closed. (The warning is also displayed on the
multi-information display.)
The buzzer stops in the following manner.
• Turn the lamp switch to the “OFF” posi-
tion.
• Close the driver’s door.
Lamp monitor buzzer
E00506100096
[When the engine was started using the key]
If the driver’s door is opened when the key is in the
“LOCK” or “ACC” position or removed from the
ignition switch while the lamps are on, a buzzer
will sound to remind the driver to turn off the lamps.
[When the engine was started using the keyless op-
eration function]
If, while the lamps are illuminated, the ignition
switch is set to the “LOCK” or “ACC” position, or
the driver’s door is opened with the ignition switch
set to the “LOCK” position, a buzzer will sound to
remind the driver to turn off the lamps.
In both cases, the buzzer will automatically stop if
the auto-cutoff function is activated, the lamp
switch is turned off, or the door is closed.
Dipper (High/Low beam change)
E00506200374
When the lamp switch is in the “ ” position, the
beam changes from high to low (or low to high)
each time the lever is pulled fully (1). While the high-
beam is on, the high-beam indication lamp in the in-
strument cluster will also illuminate.
Headlamp flasher
E00506300199
The high-beams flash when the lever is pulled slight-
ly (2), and will go off when it is released.
When the high-beam is on, the high-beam indica-
tion lamp in the instrument cluster will illuminate.
NOTE
l The high-beams can also flash when the
lamp switch is OFF.
l If you turn the lamps off with the headlamps
set to high-beam, the headlamps are automat-
ically returned to their low-beam setting
when the lamp switch is next turned to the
“
” position.
Welcome light (for vehicles equipped
with the keyless entry system or the
keyless operation system)
E00528900342
Except for vehicles for Russia, Kazakhstan and Uk-
raine, this function turns on the position and tail
lamps for about 30 seconds after the UNLOCK
switch (A) on the remote control transmitter is press-
ed when the combination headlamps and dipper
switch is in the “OFF” or “AUTO” position (for ve-
hicles equipped with the automatic lamp control).
On vehicles equipped with automatic lamp control,
the welcome light function will operate only when
it is dark outside the vehicle.
NOTE
l While the welcome light function is operat-
ing, perform one of the following operations
to cancel the function.
• Push the LOCK switch (B) on the remote
control transmitter.
Instruments and controls
3-46
3
OG4E12E1