Mitsubishi Lancer Sportback, Owner'S Manual, Page: 109 / 433

Information screen (when the ignition
switch is turned from “OFF” to “ON”)
E00520700865
When the ignition switch is turned to the “ON” po-
sition, the display screen switches in the following
order.
Type 1
Type 2
1- Screen when the ignition switch is “OFF”
2- System check screen
3- Screen when the ignition switch is “ON”
System check screen
When the ignition switch is turned to the “ON” po-
sition, the system check screen is displayed for
about 4 seconds. If there is no fault, information
screen (when the ignition switch is “ON” ) is dis-
played.
If there is a fault, the screen changes to warning dis-
play.
Refer to “Warning display list (when the ignition
switch is “ON”)” on page 3-30.
Type 1 Type 2
NOTE
l The system check screen display varies de-
pending on the customer’s equipment.
Service reminder
When the time for periodic inspection arrives, the
warning display is displayed for a few seconds af-
ter the ignition switch “ON”. Refer to “Service re-
minder” on page 3-12.
Type 1
Type 2
ACD (Active centre differen-
tial system) control mode dis-
play screen*
E00526900058
The ACD operation status is displayed.
Refer to “ACD control mode switch” on
page 4-44.
mark display screen (when
the ignition switch is “ON”)
E00520900245
This is displayed when you press the mul-
ti-information meter switch and switch
the warning display screen.
This mark is also displayed if there is an-
other warning other than the one dis-
played.
When the cause of the warning display
is eliminated, the mark goes out auto-
matically.
Instruments and controls
3-10
3
OG4E12E1