USB port (for charging)
7-18
For pleasant driving
7
E00778300196
The USB port (for charging) can be used as a
power source of the USB appliances when the
operation mode is in ON or ACC.
There are two USB ports (for charging)
located on the back of the floor console box.
When using the USB port (for charging),
open the lid and connect the USB connector
cable to it.
NOTE
Accessory socket and 220 V AC power out-
let can be used simultaneously. Refer to
“Accessory socket” on page 7-16.
If the plug of the electrical appliance was
loose or wobbled when inserted in the outlet,
replace the 220 V AC power outlet by an
authorised MITSUBISHI MOTORS dealer.
Never leave the vehicle, perform refueling or
washing the vehicle while using the 220 V
AC power outlet.
Never use electrical appliance which is vul-
nerable to vibration or heat in the cabin.
When exposed to the strong direct sunlight,
the cabin will become extremely hot. It could
cause product failure.
Electrical appliance may not operate nor-
mally and electricity supply stops by activat-
ing the built-in protection circuit under the
following conditions.
If this occurs, electricity supply restarts auto-
matically, but if it doesn’t restart automati-
cally, put the operation mode in OFF, and
then put the operation mode in ON again.
• When the power consumption of the electri-
cal appliance exceeds 150 W.
• When the battery is not fully charged.
When the 220 V AC power outlet is used
while the vehicle interior temperature is too
hot, electricity supply stops by activating the
built-in protection circuit.
If this occurs, put the operation mode in OFF
after the vehicle interior temperature is
cooled by using the air conditioning and so
on, and then put the operation mode in ON
again.
The 220 V AC power outlet can use while
the operation mode is put in ON, but use it
while the engine is running as much as possi-
ble.
If it is used for a long period while the
engine is not running, the battery could go
flat.
The following electrical appliance may not
operate normally even if the power con-
sumption is less than 150 W.
• Electrical appliance to which large current
flows momentarily
• Electrical appliance which gauges precise
data
• Electrical appliance which does not operate
normally when it is not placed horizontally
• Electrical appliance which needs extremely
stable operation
• Electrical appliance with a timer function,
which needs the consecutive output
Use of electrical appliance could cause radio
or television noise.
NOTE
The voltage of the 220 V AC power outlet
cannot be correctly gauged with a commer-
cially available tester. Consult an authorised
MITSUBISHI MOTORS dealer when you
need measurement of the voltage.
Also refer to the instruction manual and label
accompanying the electrical appliance.
USB port (for charging)
NOTE
