Multi Around Monitor*
Starting and driving 6-117
6
The Multi Around Monitor can only be used
when the operation mode is ON.
When you place the selector lever in the “R”
(REVERSE) position, the bird’s-eye
view/rear view is displayed on the screen of
the SDA or the SDA navigation system.
When you move the selector lever to any
other position, the display disappears.
When the switch (A) is pressed, the bird’s-
eye view/front view is displayed.
• When the light of the sun or the light from a
vehicle’s headlamps shines directly into the
lens.
• If a fluorescent light shines directly into the
lens, the screen indication may be flicker.
There is no abnormality.
If the camera is hot and is then cooled by
rain or a car wash, the lens can mist up. This
phenomenon does not indicate a malfunc-
tion.
If the atmospheric temperature is extremely
hot or extremely cold, the camera images
may not be clear.
There is no abnormality.
If a radio set is installed near the camera, the
camera images may cause electrical system
interference and the system may stop func-
tioning properly.
It is not possible to fully see obstacles when
the lens is dirty. If the lens becomes contami-
nated by water droplets, snow, mud, or oil,
wipe off the contamination, taking care not
to scratch the lens.
Please observe the following cautions. Ignor-
ing them could lead to a camera malfunction.
• Do not subject the camera to physical shock
such as striking it strongly or throwing a
thing.
• Do not adhere organic substances, waxes,
oil remover, and glass cleaner to the cam-
era.
If adhered to them, immediately wipe off.
NOTE
• Do not splash the camera with boiling
water.
• Never spray or splash water on the camera
or around it.
• Do not disconnect, disassemble or modify
the camera.
• Do not scratch the camera, as this may
cause damage to the camera images.
How to use the Multi Around
Monitor
Operation with the selector lever
NOTE
The passenger’s side screen can be switched
to the side view by pressing the switch.
NOTE
Operation with the switch
Type 1
Type 2