Mitsubishi MOTORS Eclipse Cross 2019, Owner'S Manual, Page: 268 / 602

CAUTION
• When there is an abnormality in the sys-
tem (When the ACC detectes an abnor-
mality, “ACC SERVICE REQUIRED” is
indicated.)
l
The ACC makes neither acceleration nor de-
celeration control and only issues warning in
the following situation.
• The vehicle in front is in a park or moving
at an extremely slow speed.
l The ACC may not be able to maintain the
set speed or the distance to a vehicle in front
and may not alert the driver, if the system
cannot detect the vehicle in front properly, in
the following situations.
• When a vehicle cuts in front of your vehi-
cle very closely.
• When a vehicle in front is offset to the left
or right.
• When a vehicle in front is towing a trailer.
• The vehicle in front is moving at a speed
much lower than your vehicle’s.
• A motorcycle or a bicycle.
• A freight trailer that is not carrying a con-
tainer.
• The vehicle has a protruding load from
the carrier.
• The vehicle has a low vehicle height.
• The vehicle has an extremely high ground
clearance.
• When there is repeated steep uphill and
downhill driving.
• When driving on an irregular or uneven
road surface.
CAUTION
• When being driven in a tunnel.
• When you are carrying extremely heavy
loads in the rear seats or luggage area.
• After the engine starting for a while.
• When driving in curved sections of road
including their entrance/outlet or running
beside a closed lane in a traffic work or
similar zone.
• When the cover part in front of the sensor
and the sensor become dirty or have snow
and ice* adhering to it.
• When water, snow or sand on the road are
extorted by the vehicle in front or an on-
coming vehicle*.
*: After the ACC control has been cancel-
led automatically due to detection of a
state of decline in performance, the ACC
will not operate in the temporary condi-
tion and will inform the driver by buzzer
and indication. When the ACC is in the
state in which it can operate, indication is
cancelled.
Should indications not be cancelled, then
there is a possible abnormality in the sys-
tem.
Please contact a MITSUBISHI MOTORS
Authorized Service Point.
Cruise control switch
1- ACC ON/OFF switch
Used to turn on and off ACC or the
cruise control function.
2- “SET -” switch
Used to set a desired speed and to reduce
the set speed.
3- “RES +” switch
Used to make ACC operate at the origi-
nally set speed and also to increase the
set speed.
4- “CANCEL” switch
Used to cancel the control function of
ACC or the cruise control.
5- ACC distance switch
Used to change the setting of the follow-
ing distance between your vehicle and a
vehicle in front.
Adaptive Cruise Control System (ACC)*
6-82
OGKE20E1
Starting and driving
6