-
72
-
(6) Service mode (Trouble mode access function)
This air conditioner is capable of recording error displays and protective stops (service data) which have occurred in the past. If
self-diagnosis displays cannot be confirmed, it is possible to get a grasp of the conditions at the time trouble occurred by checking
these service data.
(a) Explanation of terms
Explanation
Term
Service mode
Service data
The service mode is the mode where service data are displayed by flashing of the display lights
when the operations in item (b) below are performed with the indoor controller.
These are the contents of error displays and protective stops which occurred in the past in the air
conditioner system. Error display contents and protective stop data from past anomalous
operations of the air conditioner system are saved in the indoor unit controller’s non-volatile
memory (memory which is not erased when the power goes off). There are two types of data,
self-diagnosis data and stop data, described below.
Self-diagnosis data
Stop data
These are the data which display the reason why a stop occurred when an error display(self-
diagnosis display) occurred in an indoor unit. Data are recorded for up to 5 previous occurrences.
Data which are older than the 5th previous occurrence are erased.
In addition, data on the temperature of each sensor (room temperature, indoor heat exchanger,
outdoor heat exchanger, outdoor air temperature, discharge pipe), remote controller information
(operation switching, fan speed switching) are recorded when trouble occurs, so more detailed
information can be checked.
These are the data which display the reason by a stop occurred when the air conditioning system
performed protective stops, etc. in the past. Even if stop data alone are generated, the system
restarts automatically. (After executing the stop mode while the display is normal, the system
restarts automatically.) Data for up to 10 previous occasions are stored. Data older than the 10th
previous occasion are erased.
( Important) In cases where transient stop data only are generated, the air conditioner system
may still be normal. However, if the same protective stop occurs frequently (3 or
more times), it could lead to customer complaints.
(b) Service mode display procedure
NO
NO
(*1)
YES
YES
Start
Did a buzzer located in
the indoor unit sound?
Are other data displayed?
Within 1 minute after turning the air conditioner’s
power on, signals will be sent from the remote
controller
(*2)
Count the number of times the RUN light and
TIMER light flash
(*3)
, and check the contents of the
error, etc. from the table. (See page 75.)
Change the remote controller settings based on
the instructions in the table
(*4)
. (See page 73.)
*1: If the buzzer does not sound no matter how
many times you repeat the operation, the
unit ON/OFF button may be faulty.
*2:
Set the remote controller settings on “Cool
-
ing
Operation,” “Fan Speed: MED” and “Set
Temperature: 21ºC.”
Turn off the air conditioner’s power to terminate the
service mode. If you are going to turn the power on
again, wait 1 minute or longer after turning it off.
Turn the air conditioner’s power on again while
pressing the unit ON/OFF button.
Turn off the air conditioner’s power once, then
wait 1 minute or longer.
When the optional wired remote control is used:
When the service mode is effective and the
optional wired remote controller is used, the
signal from the wired remote controller won't be
received. Use the self diagnostic function with
the wireless remote controller.
