100
OCH737
13-1. SMOOTH MAINTENANCE
13-1-1. <PAR-4xMAA ("x" represents 0 or later)>
Maintenance data, such as the indoor/outdoor unit’s heat exchanger temperature and compressor operation current can be
displayed with “Smooth maintenance”.
This cannot be executed during test operation.
Depending on the combination with the outdoor unit, this may not be supported by some models.
13 EASY MAINTENANCE FUNCTION
Smooth maintenance
Return:
Page
Ref.address
Cool
Sub cool
OU TH4 temp.
OU TH6 temp.
OU TH7 temp.
●
Reduces maintenance work drastically.
●
Enables you to check operation data of the indoor and outdoor units by remote controller.
Furthermore, use of maintenance stable-operation control that fixes the operating frequency, allows smooth inspection, even for
inverter models.
Remove the
service panel.
Measure
the intake air
temperature.
Measure the discharge
temperature.
Measure the outside
air temperature.
●Indoor unit ●
●Outdoor unit ●
Smooth Mainte-
nance Function
●
Conventional inspection work
Easy maintenance information (unit)
Compressor
Outdoor unit
Indoor unit
Accumulated operating
Heat exchanger
7
Intake air
time (
o
10 hours)
temperature (
:
)
temperature (
:
)
Number of ON/OFF
Discharge
8
4
5
1
2
9
6
3
Heat exchanger
times (
o
10 times)
temperature (
:
)
temperature (
:
)
Operating
Outside air
Filter operating
current (A)
temperature (
:
)
time* (Hours)
* The filter operating time is the time that has elapsed since the filter was reset.
Discharge temperature 60°C
Continue to the next page
Check menu
Cursor
Service menu:
Error history
Diagnosis
Smooth maintenance
Request code
Smooth maintenance
Begin:
Smooth maintenance
Exit:
Ref.address
Stable mode
Cursor
－
Address
＋
Ref.address
Stable mode
Stabilization→Collecting
Cool
/ Heat/ Normal
Cool
/ Heat/ Normal
Select "Smooth maintenance" with the F1 or F2 button, and
press the [ ] button.
Select "Check" with the F1 or F2 button, and press the [ ] button.
1
Select "Service" from the Main menu, and press the [ ] button.
2
Set each item.
Select the item to be changed with the F1 or F2 button.
Select the required setting with the F3 or F4 button.
■
<Ref.address>setting [ 0 ] – [ 15 ]
■
<Stable mode>setting [ Cool ] / [ Heat ] / [ Normal ]
Press the [ ] button, Fixed operation will start.
Note: Stable mode will take approx. 20 minutes.
F1
F2
F3
F4
