85
OCH737
11-1-3. Selecting functions using the wireless remote controller <PAR-SL100A-E>
Fig. 11-1
Fig. 11-3
Fig. 11-2
Fig. 11-4
1 Going to the function select mode
Press the
button between of 5 seconds.
(Start this operation from the status of remote controller display turned off.)
[CHECK] is lit and "00" blinks. (Fig. 11-1)
Press the button to set the "50".
Direct the wireless remote controller toward the receiver of the indoor unit
and press the
button.
2 Setting the unit number
Press the button to set unit number A. (Fig. 11-2)
Direct the wireless remote controller toward the receiver of the indoor unit
and press the
button.
3 Select a mode
Press the button to set Mode number B. (Fig. 11-3)
Direct the wireless remote controller toward the receiver of the indoor unit
and press the
button.
Current setting number:
1=1 beep (1 second)
2=2 beep (1 second each)
3=3 beep (1 second each)
4 Selecting the setting number
Use the button to change the Setting number C. (Fig. 11-4)
Direct the wireless remote controller toward the receiver of the indoor unit
and press the
button.
5 To select multiple functions continuously
Repeat select 3 and 4 to change multiple function settings continuously.
6 Complete function selection
Direct the wireless remote controller toward the sensor of the indoor unit
and press the
button.
Note:
Make the above settings on Mr. Slim units as necessary.
• Be sure to write down the settings for all functions if any of the initial
settings has been changed after the completion of installation work.
A
B
C
