Mitsubishi Electric par-u02meda, Installation Manual

Page: 12 / 272

– 11 –
7 Set the M-NET addresses.
* The factory setting for the rotary switches is 01.
** M-NET address can be changed with or without the power being applied to the controller.
The screen will jump to the [Start-up] screen.
Group information for indoor units and AHC units will be deleted, but the rest of the information
will be retained.
8 Install the front cover on the top case.
Two mounting tabs are at the top of the front cover.
Hook those two tabs onto the top case, and click the front cover into place. Check that the case is
securely installed and not lifted.
Address range Address setting method
Main remote controller 101 to 150
Address that equals the lowest address of the
group plus 100
Sub remote controller 151 to 200
Address that equals the lowest address of the
group plus 150
Rotary switch setting Address
01 to 99 101-199 with the 100's digit automatically set to 1
00 200
012
3
45
6
7
8
9
012
3
45
6
7
8
9
Rotary switches
10's digit
(Above)
1's digit
(Below)
(Ex: Address 108)
To set the address, turn the rotary switch
with a precision slotted screwdriver [(-), 2.0
mm (1/16 in) (W)] to a torque of less than
19.6 N to avoid the damage to the rotary
switches.
Important
Should not
be lifted
Wall
When attaching the front cover to the top
case, push it until it they click into place.
If they are not properly locked into place,
they may fall, causing personal injury,
controller damage, or malfunctions.
Important
WT06829X02.book Page 11 Wednesday, June 26, 2013 4:03 PM