61
DISASSEMBLY INSTRUCTIONS
12
(1) Slide the sleeve and check if there is a locking lever or not.
(2) The terminal with this connector is a terminal
with lock mechanism.
1
Slide the sleeve.
2
Pull the terminal while
pushing the locking
lever.
1
Hold the sleeve, and
pull out the terminal
slowly.
In case of terminal with lock mechanism, detach the terminal as shown below.
There are two types ( Refer to (1) and (2)) of the terminal with lock mechanism.
The terminal with no lock mechanism can be removed by pulling it out.
Check the shape of the terminal and work.
<"Terminal with lock mechanism" Detaching points>
Connector
Sleeve
Locking lever
OPERATING PROCEDURE
PHOTOS
1. Removing the front panel
(1) Remove the screw caps at the down of the front panel.
Remove the screws.
(2) Pull the panel down to your side slightly and unhook the
catches at the top.
12-1. MS-18RV -
MS-24RV -
INDOOR UNIT
E1
E1
Photo 2
Photo 1
Front panel
Screws
2. Removing the electronic control P.C. board, the
receiver P.C. board and the display P.C. board
(1) Remove the front panel. (Refer to 1)
(2) Remove the electrical cover.
(3) Remove the screw of the terminal cover.
(4) Remove the screw of the terminal block.
(5) Unhook the catch of the lamp holder.
(6) Remove the receiver holder and the receiver P.C. board.
(7) Remove the screw of the ground wire.
(8) Disconnect all the connectors and all the lead wires on the
electronic control P.C. board.
(9) Remove the electronic control P.C. board and display P.C.
board.
Screw of
the termi-
nal block
Indoor
electronic
control
P.C. board
Receiver
holder
Receiver
P.C. board
Display
P.C. board
Lamp
holder
OB271--3.qxp 2/7/01 9:07 AM Page 61
