Install the
refrigerator.
Installation area
Use a dedicated outlet
Warning
At least 10cm
At least 2cm
Non-freon refrigerants are flammable gas.
However, it is hermetically sealed, therefore,
leaking is infrequent.
1. Do not use electric items or fire equipments
near by.
2. Open the window and ventilate the room.
And then contact the retail store you have
purchased from for further instructions.
Heat builds up in exterior walls of the
refrigerator
When the refrigerator is first used and during the
summer heat build-up can exceed 50-60˚C
to allow heat to escape from the ceiling and the
sides of the refrigerator
Dedicated
outlet that meets
the specified rating.
Warning
Warning
Just in case of having damaged
the refrigerant circuit.
Using outlets that do not meet the specified rating or plugging in too many leads
into a single socket can cause heat build up or fire.
Do not close the ventilation hole of the
refrigerator or the crack around the refrigerator.
If the refrigerant leaks, ignition or explosion
may be caused.
Connect the power supply.
*Connect power supply soon after
installing the refrigerator.
Make sure this unit is properly grounded.
Use a dedicated outlet for the power supply that meets the rating specified on the
rating label. (The rating label is located on the door-liner of the refrigerator
compartment.)
Prevention of television noise or image disturbance.
A place away from other devices
The installation area should not be
exposed to direct sunlight or hot
air, and should be well-ventilated
to avoid diminished cooling power and to
economise on the cost of electricity.
to prevent rusting
It should have little humidity
to prevent vibration and noise, half-shut doors, and
tilted doors.
It should be strong and level
Install a strong plate or board under the
refrigerator if the supports easily sink into the
floor. (For prevention of deformation or
discoloration due to heat or weight)
Electrical Connections
The unit should always be plugged into its own electrical outlet.
This will provide the best performance and prevent electrical circuits from being
overloaded and causing a fire.
Make sure that the electrical outlet provides the proper voltage.
Extension cords are not recommended.
The refrigerator will not be damaged even if the power is
supplied soon after installation.
It takes a while for the refrigerator to cool, therefore
supply power as soon as possible.
Leave space for heat
ventilation
Do not cause damage to
refrigerant circuit (piping) /
Do not attach screws.
Leave at least 2cm of space on the right and
left and 10cm of space between the ceiling
and the top of the refrigerator
Fr
om Installation to Operation
From Installation to Operation
If your unit is installed in the high humidity location, not only ground connection
but also installation of an earth leakage breaker is recommended.
If the power cord is damaged, purchase a new cord from MITSUBISHI
SERVICE CENTER. Make sure that the power cord is designed for this model.
If the power cord is damaged, call our MITSUBISHI SERVICE CENTER for
the replacement, in order to avoid a hazard.
6
Summary of Contents for MR-G57N
Page 30: ...MEMO 30 ...
Page 31: ...MEMO 31 ...
