PHOTOS
OPERATING PROCEDURE
60
Photo 42
Photo 43
Photo 44
Photo 45
9. Compressor cover Elect cover Control board
Drain pan Reactor Box fan
(1) Remove 8 screws for compressor cover at the back of the
refrigerator. (See photo 42)
(2) Remove the fixing screws (3 screws) and the rivet (1 rivet) on
the elect cover on the back of the refrigerator. (See photo 43)
(3) Remove the control board by removing the connector and the
fixing screws of the lead wires.
To prevent pinching of the lead wires and poor insertion of the
connector, be sure to install the lead wires and connectors in
the appropriate positions.
(4) Remove screw (1 screw). (See photo 44)
Wash the drain pan with water in case it is dirty.
(5) Remove the drain pan while bending upward the wiring inside
the drain pan.
Note:
Avoid bending or crushing the piping.
(6) Remove the screws (2 screws). (See photo 45)
(7) Remove the reactor by removing the holders (2 positions) and
the connector. (See photo 46)
(8) Remove the connector.
(9) Pull out the box fan by removing the fixing screw (1 screw) (See
photo 44) and the connector.
Compressor
cover
Screws
Box fan
Drain pan
Screw
(Drain pan)
Screw (Box fan)
Screws
Screw
Screw
Rivet
Compressor
Reactor
Reactor
Screws
Holder
Holder
Photo 46
Elect cover
Connector
Compressor cover
Drain pan
Caution
Box fan
Elect cover
Control board
Caution on installation
Reactor