OPERATING PROCEDURE
PHOTOS
Glass shelf
Two-way flexishelf
Lower case
Upper case
Water tank
Ceiling of slide case
50
DISASSEMBLY INSTRUCTIONS
7
Before the power plug is removed from the socket, be sure to conduct a series of ice making test operations by touching the .
Replace the parts after the power plug is removed.
In the procedures 2, 3, 4, and 5, 3 kinds of screws and 2 kinds of rivets are used. Do not mistake one for another when installing
them.
Rivet
4 12
Stainless steel
4 12 (Black)
With metal washer
Specified screw
(painted)
Rivet
After replacing the parts, plug in the power cable and touch the to perform the self-check and the operation check of the ice mak-
ing test.
MR-B46Z-C
Photo 1
1. Parts inside the refrigerator compartment: Glass shelf
Two-way flexishelf (Front) (Back) Upper case cover
Upper case Ceiling of slide cases Lower case
Partition for chilled compartment Partition for tank
(1) Lift the front of the shelf using both hands.
(2) Pull out to the front.
Swiftly pulling out the part to the front can damage the side
of the door. Pull out the part slowly to remove it.
(3) Lift the front of the shelf using both hands. (See figure 2.)
(4) Pull out to the front. (See figure 3.)
(5) Pull the shelf out to the front and match the protruding parts to
the grooved parts of the guide rails. (See figure 4.)
(6) Take the protruding parts off the grooved parts, and then hold
up and pull out the shelf to the front to remove it.(See figure 5.)
Figure 1
Swiftly pulling out the part to the front can damage the side
of the door. Pull out the part slowly to remove it.
(1)
(2)
(4)
(3)
Back Shelf
Figure 4
Figure 2
Figure 3
Figure 5
(5)
(6)
Match the protruding parts to
the grooved parts of the guide
rails.
Guide Rail
Glass shelf
Two-way flexishelf (Front) (Back)
Front Shelf
OAH162
