Mitsubishi Electric MJ-E26CX-H, Instruction Manual

Page: 13 / 26

13
Operating
E
operation
INTELLIGENT LAUNDRY
Operations in which the unit controls
the airfl ow while monitoring the
humidity of the room, and estimates
when the laundry will dry, and
stops the unit automatically. These
operations are performed for a period
of time ranging from approximately 1
hour to 12 hours.
Rough
Guide on
Usage
Size of room
Amount of
laundry
Up to approx.
17 m 2
Up to approx.
6kg
Keep usage within the ranges
specifi ed in “Rough Guide on Usage”
to ensure effi cient drying.
Information
Drain the tank before use.
The unit may stop before the laundry
dries because of a full tank.
If this is used in conjunction with the
off timer, operation may stop before
the clothes are dry.
P17
When the room temperature is
approximately 5°C or less, operation
stops after about 1 hour because the
evaporation of moisture becomes
diffi cult and the clothes will not dry.
In such a case, use the unit with
dehumidifying set to HIGH.
When you want to
perform manual operation
You can select from fi ve operating modes: HIGH, LOW, BATHROOM
MILDEW GUARD, LOW TEMP, and AUTO. (HIGH, LOW, and LOW
TEMP: P14 , BATHROOM MILDEW GUARD: P15 )
AUTO
When you want to set the humidity and perform dehumidifying
1 2
1
Press
P12
2
Press to select the operating mode
A border is
displayed around
AUTO.
Information You can also switch to AUTO with the MODE switch.
<To stop operation>
Press
P12
AUTO
The unit changes the airfl ow rate automatically and
operates intermittently to maintain the set humidity.
If the current humidity becomes lower than the set
humidity, the unit stops dehumidifying (blowing and the
louvre are stopped). If the current humidity becomes
higher than the set humidity, the unit resumes operation.
Operation is performed for approximately 6 minutes
after you turn the power ON, regardless of the humidity
of the room.
The humidity may not become lower when the door
of the room is opened and closed frequently or
depending on the size and conditions of the room.
Information
<Checking the set humidity and setting the humidity>
Press
Press the
switch again.
Press the switch once
to display “SELECTION”
and then the current
humidity setting.
After 3 Sec.
The indication changes to
the current humidity after
approximately 3 seconds.
Pressing the
switch again while
“SELECTION” is
displayed allows you to
set the humidity setting.
Each time the switch is
pressed, the humidity
setting changes.
65 70 50 55 60
e̲mj̲e26cx̲h.indb 13 e̲mj̲e26cx̲h.indb 13 2009/10/26 17:22:22 2009/10/26 17:22:22