Mitsubishi Electric MAC-567IF, Installation And Operation Manual

Page: 23 / 68

MELCLOUD
4. Setup
To set up and use the MELCloud with the internet, perform the following steps or use the included quick reference guide.
4.1 Initial state
Turn on the main switch on the ATA/ATW or Lossnay unit. When the LED display shows the initial state indicated in the
right column, the wi-fi adapter can be connected to the router.
Note: It takes several minutes before the initial state is reached.
INITIAL STATE
ERR OFF
NET OFF
MODE OFF
UNIT ON
4.2 Mode selection
The wi-fi adapter has to first be connected to the router before it can be used for communication between the indoor unit
and the MELCloud. There are three ways to connect the wi-fi adapter to the router:
• WPS-PUSH mode
• Access point mode
• WPS-PIN mode
Which mode should be set depends on whether your router has a WPS button. Please use the pairing mode best suited
to your system. Refer to the table below for information on how to set the pairing mode using the MODE button. If the
router is replaced, the wi-fi interface has to be configured again.
With WPS button Without WPS button
WPS-PUSH mode Access point mode WPS-PIN mode
Read section 2.5 to learn how to set up WPS-PIN mode
MODE switch
PUSH
0 sec. 1 sec. 5 sec. 10 sec.
MODE LED
(orange)
ON
OFF
Flashes
every second
Flashes every
0.5 seconds
Lights up for 5 seconds
Release for 1 to 5 seconds Release for 5 to 10 seconds Release after 10 seconds
The MODE LED flashes every second The MODE LED flashes every 5 seconds The MODE LED flashes every 0.5 seconds
Continue with 4.3 Continue with 4.4 Continue with 4.5
Cancel process
Press RESET for 2 seconds to
return to the initial state (4.1).
Press MODE again for 5 to 10 seconds
to return to the initial state (4.1).
Press RESET for 2 seconds to
return to the initial status (4.1).
Software information 2019 /
23