─
26
─
SW5
Type
Exhaust fan stop at outdoor air
temperature of -15 °C or lower *
ON : Both Air supply fan and Air exhaust fan stop
OFF: Air exhaust fan operation (Only Air supply fan stopped) (Factory
setting)
9
Not in use
Note 3
Fixed at OFF
10
Name
Specification
Note 1: When PZ-41SLB-E is used, the settings will be disabled for SW2-6, SW 5-1, SW5-4, SW5-5, SW5-7,
and SW5-8.
(
Operation after a recovery from a power failure will be
fi
xed at power failure automatic recovery, and
functions other than this will be according to the setting of PZ-41SLB-E.)
Note 2: All of the aforementioned switches (SW2, and SW5) are in the OFF position at the factory setting.
When replacing the circuit board, set the new board to the same setting as that of the board prior to
replacement.
Note 3: Do not change the setting. (Lossnay will not operate properly.)
• Main/Sub selection switch
In systems of only one Lossnay unit, be sure to set it to “Main”.
In systems with multiple Lossnay units, be sure that one unit is set to “Main”, and that all the others are
set to “Sub”.
When interlocked with an external device, be sure to connect the external device to the Lossnay that is
set to “Main”.
(11) Function selection with PZ-60DR-E
When PZ-60DR-E is used, function selection can be made from the remote controller.
Functions can be switched from PZ-60DR-E even after the function selection switches have been set on the
Lossnay circuit board.
( Settings from PZ-60DR-E will have priority over function selection switch settings of the Lossnay circuit
board.)
When two remote controllers are used, “LOSSNAY FUNCTION” and “INTERLOCK SETTING” can be set only
on the “Main” remote controller.
The “Main” and “Sub” remote controller will be determined automatically by communication when the main unit
power is turned on. The remote controller on which “LOSSNAY FUNCTION” and “INTERLOCK SETTING” are
displayed is the “Main” remote controller.
* For information about operation of PZ-60DR-E, refer to the Lossnay remote controller PZ-60DR-E Installation
Manual and the Operating Instructions.
Not in use
Note 3
Fixed at ON
1
SW6
Not in use
Note 3
Fixed at OFF
2
Not in use
Note 3
Fixed at OFF
3
Not in use
Note 3
Fixed at OFF
4
