35
Start/stop from the operation panel (PU
3.4.3
Use switches to give a start command and a frequency command (multi-speed
setting)
[Connection diagram]
POINT
· Use
/
to give a start command.
·
Pr. 79 Operation mode selection
must be set to "4" (external/PU combined operation mode 2)
· The initial values of the terminals RH, RM, RL are 50Hz, 30Hz, and 10Hz.
(Refer to page 43 to change frequencies
using Pr. 4, Pr. 5 and Pr. 6.)
· Operation at 7-speed can be performed by turning on two (or three) terminals simultaneously.
(Refer to
Instruction Manual (applied).)
ON
ON
ON
ON
ON
ON
ON
ON
ON
ON
ON
Output frequency (Hz)
Speed 1
(High speed)
Speed 2
(Middle speed)
Speed 3
(Low speed)
Speed 4
Speed 5
Speed 6
Speed 7
Time
RH
RM
RL
Three-phase
AC power supply
Motor
Inverter
R/L1
S/L2
T/L3
U
V
W
High speed
Middle speed
Low speed
RH
RM
RL
FR-DU07
,
PC
Display
Operation
Flicker ··· Parameter setting complete!!
Flickering
The parameter number
read previously appears.
1.
Screen at powering on
The monitor display appears.
2.
Press to choose the parameter setting
mode.
3.
Turn until (
Pr. 79
) appears.
4.
Press to read the currently set value.
" "(initial value) appears.
5.
Turn to change it to the
setting value " ".
6.
Press to set.
7.
Mode/monitor check
Press twice to choose the
monitor/frequency monitor.
8.
Press the start switch (or ).
FWD (or REV) flickers.
When the frequency command is not
given, it flickers.
Summary of Contents for FR-F 700 EC
Page 2: ......
Page 142: ...MEMO ...
