D700 QUICK START MANUAL
11
n
BASIC OPERATION (FACTORY SETTING)
STOP
Operation mode switchover
Parameter setting
Faults history
Monitor/frequency setting
At powering ON (External operation mode)
PU operation mode
(output frequency monitor)
Parameter setting mode
PU Jog operation mode
Output current monitor
Output voltage monitor
Display the
present setting
Value change
Value change
Parameter write is completed!!
Parameter and a setting value
flicker alternately.
Parameter clear
All parameter
clear
Faults history clear
Initial value
change list
(Example)
(Example)
Frequency setting has been
written and completed!!
and frequency flicker.
[Operation for displaying faults history]
Past eight faults can be displayed.
(The latest fault is ended by ".".)
When no fault history exists,
is displayed.
(Refer to page 55)
n
EASY OPERATION MODE SETTING (EASY SETTING MODE)
Setting of Pr. 79 Operation mode selection according to combination of
the start command and speed command can be easily made.
Start command: external (STF/STR), frequency command: operate
with Setting Dial.
y
a
l
p
s
i
D
n
o
it
a
r
e
p
O
1.
Screen at powering on
The monitor display appears.
2.
Press
and
for 0.5s.
3.
Turn
until
appears.
(refer to the table below for other settings)
4.
Press
to set.
Flicker ··· Parameter setting complete!!
The monitor display appears after 3s.
Flickering
Flickering
Flickering
Operation Panel Indication
Operation Method
Start command
Frequency command
External
(STF, STR)
Analog
voltage input
External
(STF, STR)
Analog
voltage input
Flickering
Flickering
Flickering
Flickering
Flickering
Flickering
Flickering
Flickering
NOTES
is displayed ... Why?
Parameter write is disabled with “1” set in Pr. 77.
is displayed ... Why?
Setting can not be made during operation. Turn the start switch
(
, STF or STR) OFF.
• Press
before pressing
to return to the monitor display
without setting. In this case, the mode changes to External operation
mode when performed in the PU operation mode (PU JOG
operation mode) and to PU operation mode when performed in the
External operation mode.
• Reset can be made with
.
• The priorities of the frequency commands when Pr. 79 = “3” are
“Multi-speed operation (RL/RM/RH/REX) > PID control (X14) >
terminal 4 analog input (AU) > digital input from the operation panel”.
MitsubishiElectric Automation, Inc.
