English-14
P-2
Installing the monitor
Carry out as necessary
Installing and removing the stands
The stands are available as option.
Refer to the user’s manual of the stand for more information.
How to install the stands
1. Turn the monitor off.
2. Fasten screws on both sides of the monitor.
NOTE:
Install the stands so that their longer portions come to the front.
How to remove the stands
1. Spread the protective sheet on a fl at surface, such as a
desk.
2. Place the monitor on the protective sheet.
3. Remove the screws with a screwdriver and place them in a
safe place for reuse.
Installing the main switch cover
To prevent unauthorized operation of the main power switch,
attach the main switch cover, which is supplied as an
accessory.
NOTE:
With the main power switch cover in place, the main power
switch cannot be turned off. Remove the main power switch
cover in order to switch off the monitor.
Screw x 2
(Accessories of
the option stand)
Option stand x 2
(Longer portion comes to the front.)
Screw x 2
(Accessory)
Main switch cover
(Accessory)
Using the wall mount or ceiling mount
Lay the screen face down
Lay the protective sheet on a table, which was wrapped around
the monitor when it was packaged, beneath the screen surface
so as not to scratch the screen surface.
This device cannot be used or installed without the Tabletop
Stand or other mounting accessory. Failure to follow the correct
mounting procedures can result in damage to the equipment or
injury to the user or installer. Product warranty does not cover
damage caused by improper installation.
Failure to follow these recommendations can void your
warranty.
Use M6 screws (having a length 10 mm longer than the
thickness of the mounting bracket) and tighten them securely.
Prevent the screws from loosening using spring washers, etc.
MITSUBISHI ELECTRIC recommends using mounting interface
that comply with TÜV-GS and/or UL1678 standard in North
America.
CAUTION:
For preventing the monitor from falling.
• Install the monitor with metal brackets for wall or
ceiling installation (commercially available) on your own
responsibility. For detailed procedures of installation, refer
to the instructions of the metal brackets.
• To lessen the probability of injury and damage resulting
from fall of the monitor in case of earthquake or other
disaster, be sure to consult the bracket manufacturer for
installation location.
• To lessen the risk of falling of the monitor, thread
commercially available rope through the handles at the
right and left of the monitor and secure the rope to the wall
mount brackets or ceiling mount brackets.
• Do not sleep where the monitor may topple over or fall in
case of an earthquake or other disaster.
511.5
511.5
100
100
100
100
Protective
Sheet
Tabletop Stand
(mm)
Table
30
7
30
7
10
0
1
0
0
