Care,
service, and
troubleshooting
Use only a soft, dry cloth to clean your
M-Cube satellites. Do not use abrasives as you
will risk damaging the finish. Refer to wrap
packaging for washing instructions.
T R O U B L E S H O O T I N G G U I D E
O V E R D R I V E P R O T E C T I O N
S A T E L L I T E C A R E
P R O D U C T S E R V I C E
Should a fault occur with your loudspeaker system, please return the product in its original
packaging. Product for service should be returned to the dealer from whom the product was
purchased. If you experience difficulties or there is no Mission dealer in your area, please contact
the Mission distributor for your country, or the Main Service Centre for your country.
Your M-Cube satellites are independently
protected by overdrive detection circuitry:
If the input signal level exceeds the safe
operating threshold on a particular channel,
the satellite volume will cut significantly on that
channel. If this occurs, the receiver volume
control should be reduced to zero for
approximately 15 seconds, after which the
volume can be increased to a safer level, and
normal function will return.
Protection devices may have tripped - turn
volume down for 15 seconds.
Low sound output
Check all connections; ensure AV receiver
is set to correct input channel; ensure
volume is above zero; ensure subwoofer
power status indicator is live; ensure
source is connected and powered up.
No sound coming
from satellites
In stereo / 5-channel stereo modes, some
receivers will route bass information to the
subwoofer via the LFE channel. If so, you
should set the subwoofer to ‘OFF’ in your AV
receiver’s speaker setup when listening to
2-channel sources.
Bass sounds boomy in
2 channel (stereo) mode
Check receiver is not in stereo mode; check
all connections.
Only 2 channels are audible
m-cube sats manual 03-11-04.qxd 15/12/2004 08:23 Page 10
