![background image](http://html1.mh-extra.com/html/mircom/fx-3318/fx-3318_installation-and-operation-manual_1805768036.webp)
30
Operation
•
If Aux disconnect is not active, activates all non-disconnected indicating circuits
programmed to the input.
•
Activates non-disconnected strobes associated with the input.
•
Activates non-disconnected signals associated with the input at the evacuation rate.
In a pre-configured FACP the Positive Alarm Sequence may be enabled or disabled as the
user requires. For more information on enabling or disabling the Positive Alarm Sequence see
section 5.7.1 Enabling or Disabling the Positive Alarm Sequence.
5.7.1 Enabling or Disabling the Positive Alarm Sequence
Enabling or Disabling the Positive Alarm Sequence is done using the numeric keypad. For
more information on how to use the Numeric Keypad see section 6.2.1 Numeric Keypad and
Cursor Buttons on page 47. For details on configuring the FACP for PAS see LT-1148MOD
FX-3318 Series Programming Manual.
How to Enable or disable the Positive Alarm Sequence
1. From the Keypad of the FACP press
M
to enter the
Menu
.
2. Using
the
Up and Down
cursor buttons, scroll to
Operation
.
3. Press
Enter.
4. In
the
Operation Menu
scroll to
Positive Alarm
.
5. Press
Enter
.
6. You will now see the current status of the
Positive Alarm Sequence
and will be
prompted to change status.
Figure 8 Enabling the Positive Alarm Sequence
7. To change the status press
Enter
.
8. To exit without changing the status press
Cancel
.
Note:
There will be no notification message advising a change of status.
Pos Alarm disabled
Enable? Y
i
Summary of Contents for FX-3318
Page 2: ......