Installation and Programming Manual
Mircom Technologies Inc
All Rights Reserved
LT-1034 Rev.1
Page 29 of 54
5.7 Entering the Date and Time
Access Level 1
Select [
ADMINISTRATION
]
[
SET
DATE/TIME
]
The date is MM/DD/YY format
The time is 12 hour HH:MM
When the cursor is over the AM/PM digit, press
1
to change to
AM
, or press
7
to change to
PM.
Press
‘ENT’,
then
‘BCK’
out of programming. The time must be changed manually for Daylight Savings Time adjustments.
5.8 Alarm and Trouble Logs
Access Level 1
There are a total of 900 entries combined for alarm and trouble log archival. Once this number is surpassed, the
oldest entry will be dropped from history and replaced with the newest.
Select [
ADMINISTRATION
]
[
VIEW LOGS
]
5.9 Resetting the NMC to the Factory Defaults (required after an NMC firmware update)
Access Level 3
To reset the Factory Defaults, select [
CONFIGURE
]
[
CONFIGURE
NMC
]
[
NMC
NETWORK
]
[
FACTORY
DEFAULT
].
There will be a 1 second delay between displays of ‘Resetting Pass codes’, Followed by ‘Resetting System
Parameters’, ‘Resetting ISD Settings’ (20 sec),‘Resetting Trouble Logs’, ‘Resetting Alarm Logs’, completing by the
final acknowledgement of ‘
Factory Defaults Set
’.
SET DATE/TIME
>VIEW LOGS
CHANGE MSG UNIT
UP DWN ENT BCK
DISPLAY VERSION
>ADMINISTRATION
TEST
UP DWN ENT BCK
ALARM LOGS
TROUBLE LOGS
UP DWN ENT BCK
>SET DATE/TIME
VIEW LOGS
CHANGE MSG UNIT
UP DWN ENT BCK
DISPLAY VERSION
>ADMINISTRATION
TEST
UP DWN ENT BCK
WARNING:
RESET FACTORY
DEFAULTS?
CONT BCK
>FACTORY DEFAULT
UP DWN ENT BCK
>NMC NETWORK
SYST PARAMETERS
CONFIG RELAYS
UP DWN ENT BCK
>CONFIGURE NMC
CONFIGURE ISD
UP DWN ENT BCK
RESETTING NMC TO
FACTORY DEFAULTS
PLEASE WAIT…..
CONT BCK
ADMINISTRATION
TESTS
>CONFIGURE
UP DWN ENT BCK
11/23/04 17:35AM
DD/MM/YY HH:MM
< > ENT BCK
Summary of Contents for Fire-Link ISD-1000 Series
Page 2: ......
