Kaleido-X (7RU)
Quick Start Guide
21
To configure the IP address and other network settings of the ABT:
1. Connect a PC to a switch.
2. Referring to “Configuring a Client PC” on page 18, configure the PC with the following network
settings:
3. Apply power to the Audio Bridge Terminal and make sure it is connected to the same switch as the PC.
• If the switch is Power over Ethernet (PoE) enabled, simply connect it to the unit using an Ethernet
cable.
• If not, PoE mid-span (
inserter
) equipment must be placed between the switch and the Audio Bridge
Terminal.
4. Press the RESET button (located on the right-hand side of the ABT rear panel beside the ETHERNET/
POWER RJ-45 connector) for at least 1 second.
The Audio Bridge Terminal will reboot with the following static network configuration:
5. Using a Web browser on the PC, connect to the ABT using the following address: 10.0.3.190.
The home page of the ABT’s built-in Web server is displayed.
6. Click
Network Configuration
(in the navigation pane).
Note:
The ABT is powered through the RJ-45 Ethernet connector. There is no power ON/OFF button, so
the device is ON whenever a powered Ethernet cable (PoE) is connected.
See also:
For more information about the ABT, refer to the Audio Bridge Terminal Guide to Installation and
Operation, available on the DVD that shipped with your system.
DHCP
Off
Static IP address
10.0.0.1
Subnet mask
255.255.0.0
Default gateway
10.0.0.1
DHCP
OFF
Static IP address
10.0.3.190
Subnet mask
255.255.0.0
Default gateway
10.0.0.1