10
11
WALLMOUNT CONFIGURATION
(continued)
WARNING:
The Battery Pack must be installed in the proper up-right posi-
tion. If the Battery Pack is not installed in the proper up-right position the
Batteries will be damaged. Once the Battery Pack is placed on the wall,
looking at the front panel of the Battery Pack the top cover of the Battery Pack
MUST be on your left hand side.
3. Align the mounting brackets with the mounting bracket screw holes and
attach with the six retaining screws.
4. Use the template to mark the screw hole position on the wall.
CAUTION,
you should always were protective gear for your hands and eyes when
operating power tools.
5. Attach the four retaining screws to the wall and make sure that all of the re-
taining screws are screwed into structural material. Then clean the area
of any loose material. Do not tighten the retaining screws all the way, leave
approximately 3/8" of the retaining screws sticking out.
6. Position the Battery Pack, so that the mounting bracket keyed holes line up
with the four retaining screws. Slide the Battery Pack down until its resting
securely on the four retaining screws.
7. Tighten the four retaining screws to secure the Battery Pack to the wall.
8. The LED face plate can be rotated to read in the up-right position. Remove
the front panel from the Battery Pack. On the backside of the front panel,
push the LED face plate outwards the face plate will pop out. Position the
LED face plate so that it reads in the up-right position. Re-install the front
panel on the Battery Pack.
9. The Wallmount Configuration is complete. See Connecting the Battery
Pack.
CONNECTING THE BATTERY PACK
(QUALIFIED
SERVICE PERSONNEL ONLY)
NOTE: If you are using these Battery Packs with the Enterprise Plus LCD
RTXL series or the Endeavor LCD RTXL series UPS, the UPS must be
configured so that the UPS will report the correct estimated runtime on
the LCD screen and in the Power Monitoring software and/or the SNMP
card. See the Power Monitoring software or the SNMP card’s User's
Manual to configure the UPS.
1. Make sure that the DC circuit breaker on the rear panel of the Battery Pack
is in the Off position.
2. Turn the UPS off and disconnect the UPS's input power cord from the AC
wall outlet.
3. Remove the External Battery Connector cover from the UPS's rear panel.
4. Verify, before connecting the Battery Pack's external battery cable into the
UPS's external battery connector, that they mate red to red and black to
black.
NOTE:
The red connector is the battery positive (+) and the black
connector is the battery negative (-). Connect the external battery cable
from the Battery Pack to the external battery connector on the UPS.
NOTE:
If connecting more than one Battery Pack see Daisy Chaining.
5. See Connecting the Battery Pack to an AC Source.
NOTE: The BP72RTXL's External Battery Cable has a strain relief that
must be attached (with the screw) to the rear panel of the UPS.
BP72RTXL's External Battery Cable with strain relief.
