Decrease
Increase
How To Operate Remote Shifter
TWIN comes with a convenient remote shifter device.
By installing it on your handlebar or stem, you can adjust the resistance
level in 13 levels without getting off the bike.
The plastic band is soft enough to fit aero-shaped carbon handlebar or
round shaped stem as well as the standard round dimension handlebars.
How to install the remote shifter
1) Wind the plastic band around the handlebar
2) Hook the tip to the gutter on the plastic shifter base (Fig. V-1)
3) Flip up the lever to lock (Fig. V-2)
How to increase the resistance level
Twist the shifter dial toward "H" symbol
How to reduce the resistance level
Twist the shifter dial toward "L" symbol
!
"L" is not zero resistance. There is still some resistance
at "L" level due to the roller compression to the tire.
The remote shifter is pre-adjusted to fit the standard handlebar size;
22mm (7/8") diameter.
If it becomes loose or too tight, or you need to install the shifter onto
an oversized handlebar or stem, adjust the band length by turning the
plastic screw with an M4 hex wrench (see Fig. Y).
How To Adjust Remote Cable
If you cannot shift at L or H position, it's time to adjust the cable tension.
1) Set the remote shifter lever at "H" position and straighten the cable.
2) Pull off the black plastic cap on foot of the cable, then the adjusting
screw will appear. (Fig. Z)
3) While pushing the outer cable toward the shifter, push the adjusting
screw to the outer cable. (Fig. Z & AA)
4) Turn the lock nut until it touches the Mag unit. You shouldn't overtighten
the nut, otherwise you won't be able to set the shifter at "L" position.
5) Insert the plastic cap again.
- 7 -
Adjusting Screw
Lock Nut
Cap
Tighten nut until it touchs housing
1
2
You must release the hook
for adjusting screw
Indicator
(white dot)
!
Do not overtighten the plastic screw. It will break the
plastic band. Release the hook before adjusting.
(Fig. V)
(Fig. X)
(Fig. Y)
(Fig. Z)
(Fig. AA)
(Fig. W)
