How To Assemble U-Leg
Required Tools: 2x 5mm Hex Wrench
(supplied)
1
2
5
6
3
7
4
for 700C
for 22"~26"
650C
Choose the pivot hole for your bike size on the
main pillar. Some 26" may fit better in the upper
hole.
First, disassemble the pivot bolt.
Remove the alloy sleeve and plastic washers.
Insert the alloy sleeve into the selected hole,
and put the plastic washers on both sides.
Attach the U-Leg to the main pillar.
Check that the plastic End Plugs on the U-Leg are
inserted completely and aligned with the hole.
Then insert the pivot bolt and tighten down the screw
using the supplied M5 hex wrenches.
The center bolt is
left intentionally
loose in the
package. Lightly
tighten it.
Check to make
sure each leg
moves smoothly.
!
The center bolt is left intentionally
loose in the package. Lightly
tighten it. Check to make sure
each leg moves smoothly.
- 2 -
!
Be sure you fully insert the plastic
End Plugs to the U-Leg before
putting the pivot bolt through them.
Failure to do so will cause a
problem that the legs will not align
in same height.
Plastic Washer
Alloy Sleeve
Pivot Bolt
End Plug
U-Leg
Plastic Washer
(Fig. A)
(Fig. B)
(Fig. C)
(Fig. D)
(Fig. E)
(Fig. F)
(Fig. G)
Pivot Bolt
(Nut Side)
Pivot Bolt
(Screw Side)
Tighten
firmly
Tighten
light
