- 5 -
8
9
Now, grab the saddle of your bike and rock the bike back and forth to make sure your bike is securely
in the trainer. Your bike should not move independently of the trainer where it is attached.
Tighten the Lock Nut firmly to fix the left side coupling position. (see Fig. H)
!
If you feel the clamp lever action is too tight, spray a silicon lublicant between the plated right side
coupling steel tube and the gray plastic guide sleeve.
Do not apply wrong type lublicant, the plastic material could be damaged.
9
Make sure the rear tire is positioned as close to
the center of the roller as possible and doesn't
touch any of the plastic side pieces. (see Fig. I)
You cannot adjust the wheel position by
changing the left side coupling bolt length.
To do so, loosen the bottom side bolts of the
Mag unit then slide the unit side to side.
After adjustment, tighten the bolts firmly.
(Fig. I )
Operating Lock Pin
By moving the Lock Lever, you can engage the Lock Pin into the hole to hold the pillar in the fixed position, or
retract the pin to make the pillar free to switch to Gravity Mode.
The Lock Pin can be fixed in two positions; 1) Fixed Mode position and 2) Transporting position. It will be free in
any other area.
To move the Lock Pin, pull the Lock Lever to release the lock.
[ Retracted Lock Pin = The pillars can move freely ]
[ Inserted Lock Pin = The pillars are securely fixed ]
(Fig. J )
(Fig. K)
