- 3 -
!
How To Setup LR961
Required Tool :
13mm open wrench (NOT a closed type)
LR961 is packed in the folded condition. The pillars are folded backward, and the Mag resistance unit is folded
forward. (see Fig. A)
First, raise the pillars then set the Mag unit into position.
Lock Lever
Lock Pin
Lock Pin Hole for Transporting Mode
Lock Pin Hole for Fixed Mode
Frame
Left Side Pillar
(Fig. A)
Right Side Pillar
Mag Unit
Make sure both side Lock Levers are released from
the holes, then raise up the pillars.
While supporting the pillars, pull the Lock Lever
and slide it outward to insert the pin into the hole for
Fixed Mode. (see Fig. B)
The lever will be retracted by the inside spring. Slide
the pin until it's securely locked.
You will do this on both sides to prepare using the
trainer in Fixed Mode.
Even if you will choose Gravity Mode, set the pillars
in this position first.
Adjust the center foot length by turning it until
all 5 foot points securely touch the floor.
(see Fig. C)
If you set the the center foot too long, stability
will be compromised.
After adjustment, tighten the inside nut by
inserting a 13mm wrench from the front opening.
Make sure the Lock Pin
is securely inserted into
the hole and the pillar
is solidly supported.
(Fig. B)
(Fig. C)
Center Foot
