- 7 -
1
2
How To Use Fixed Mode
In Fixed Mode, the bike will be supported at same height level at all times. Even you apply load to the rear wheel,
the wheel position will not change. So you need to push the Drive Roller to the tire.
Maintain the pressure to the tire in correct level. It means the roller compresses the tire in the depth of 3 – 4mm.
If contact is too weak, periodic slippage will occur between the roller and the tire. it could cause premature tire wear
or pit the alloy roller surface unexpectedly.
Too much pressure will deform the tire heavily and may cause tire burst due to increased temperature.
Turn the knob counter-clockwise to raise the driver
roller up.
Keep turning the knob until the roller compressed the
tire in the depth of 3 - 4mm.
3
When you release the bike from the trainer, turn the knob clockwise to release the tire from the roller.
!
When using in Fixed Mode, maintain the tire air pressure 10% higher than usual to achieve
longer tire life.
(Fig. M)
(Fig. N)
