Minolta CL-200, Instruction Manual

Page: 31 / 56

29
11. Repeat steps 10 and 11 as necessary to set values for all digits.
◆
When you have entered values for all digits, the entire
value (all digits) will blink.
●
You can cancel the entry procedure by pressing [ CALL ].
12. Repeat steps 3 to 11 as necessary to set the correct values for all
three lines.
●
You can cancel the entry procedure by pressing [ CALL ].
13. Recheck you entries to be sure that they are right, and then press
[ SET ] to register them.
◆
The CHROMA METER computes the CF values by com-
paring your entered values with the held measurement
values.
●
If any of the computed CF values is lower than 0.0001 or higher than 10.0000, the CHROMA
METER displays the “Err A” message and forcibly cancels SET mode.
●
You can view CF values by pressing [ CF ] (to enter CF mode) and the holding down the
[ CALL ] key. The values remain on the screen until you release the key.
●
If any of the values you have entered are outside of the permissible range for the corre-
sponding parameter, the CHROMA METER displays the “Err A” error message and then
cancels SET mode (without registering any of the entered values).
●
If you attempt to set y such that y < 1-6.98x, the CHROMA METER displays the “Err A”
message and forcibly cancels SET mode.