Minnich A-1-24, Operators & Service Manual

Page: 7 / 28

7
Dowel Drill Manual
GENERAL SAFETY
∆ ALWAYS keep the machine in proper running
condition.
∆ ALWAYS become familiar with the compo-
nents of the machine before operation.
∆ Fix damage to machine and replace any bro-
ken parts immediately.
∆ ALWAYS store equipment properly when it is
not being used. Equipment should be stored
in a clean, dry location out of the reach of
children and unauthorized personnel.
∆ NEVER lubricate components or attempt ser-
vice on a running machine
∆ NEVER tamper with the factory
settings of the engine or en-
gine governor. Damage to the
engine or equipment can result
in operation in speed ranges
above the maximum allow-abil-
ity.
∆ ALWAYS Dispose of hazardous waste proper-
ly. Examples of potentially hazardous waste
include used motor oil, fuel, and fuel filters.
∆ DO NOT use food or plastic containers to
dispose hazardous waste.
∆ DO NOT pour waste or oil directly onto the
ground, down or drain or into any waste
source.
BEFORE CONNECTING THE AIR COMPRESSOR:
∆ NEVER attempt to loosen any compressed air
hose that is pressurized.
∆ KEEP AWAY from all hot or spark generating
objects, do not smoke when handling fuel.
∆ So as to facilitate shipment, new or repaired
units are not lubricated before delivery to cus-
tomers.
∆ DO NOT use hydrocarbons and especially do
not use fuel oil for lubricating purposes.
∆ DO NOT OPERATE MACHINE WITHOUT
GUARDS AND COVERS IN PLACE
∆ ALWAYS disconnect the air supply before chang-
ing steel or dismantling the tool for service or
repair. For maximum safety we advise the in-
stallation of a shut-off valve at the end of the air
line.
∆ NEVER operate the engine with heat shields or
guards removed.
∆ DO NOT remove the engine oil drain plug while
the engine is hot. Hot oil will gush out of the
engine crankcase and severely scald any persons
in the general area of the machine.
∆ Install the drill steel and bits into the drill motors
and close the latch retainers and rod guides.
∆ Make sure that the air compressor is set at an
operating pressure of not more than 120 PSIG
(8Bar)
∆ Make sure air line is cleaned out and is of the
proper size and pressure rating for the drill unit.
∆ Make sure the lubricator is filled with proper
lubricant. See Minnich recommended lubricant
below.
∆ Make sure all controls are in the “off” position
and the lift lever (if so equipped) is in the “up”
position.
∆ Make sure all lock pins are in their locked posi-
tion.