5 | minnkotamotors.com
©2022 Johnson Outdoors Marine Electronics, Inc.
8
8u
8v
ITEM(S) NEEDED
#32 x 4
Face
Face
Plate
Plate
Hook
Hook
Loop
Loop
Dust Cover
Dust Cover
Face
Face
Plate
Plate
t.
With pilot holes drilled, push the wires, Face
Plate and Plug Receptacle back in place on the
Mounting Surface.
u. Double check the location of the Hook on the back
side of the Face Plate. The Loop in the cable of the
Dust Cover should be placed in the Hook of the Face
Plate. Once secure, push the Face Plate all the way
back against the mounting surface. Ensure the Plug
Receptacle is positioned as previously noted.
v. Realign the drilled pilot holes with the screw holes on
the Face Plate. Secure the Face Plate with four #8-18
x 1-¼ Screws (Item #32) using a Phillips Screw Driver.
7r
q. Turn the entire assembly to the right or left until the
Cord from the Plug Assembly is in an acceptable
location. Check for clearance of other items on the
mounting surface and if the cord will interfere with the
operation of anything in the area.
r.
Once in an acceptable location, take a pen or marking
tool and mark the mounting surface in each of the
screw holes on the Face Plate. Make note of the
orientation of the Plug for correct placement in the
next steps of installation. With the locations marked,
remove the Plug Assembly from the Plug Receptacle
and set it aside.
s. Lift the Plug Receptacle, Face Plate and wires forward
out of the drilled hole and leave it hang out of the way.
Take a Drill with an 1/8" Drill Bit and drill pilot holes
into the Mounting Surface on the Marked Locations.
7
7q
7s
Plug Assembly
Plug Assembly
Cord
Cord
Marked Location
Marked Location
Marked Location
Marked Location
Face
Face
Plate
Plate
Plug
Plug
Receptacle
Receptacle
Face
Face
Plate
Plate
Marked Location
Marked Location
Marked
Marked
Location
Location
NOTICE:
Make sure the location also allows for the
Plug to be connected and disconnected. Then the
Locking Collar can be secured once the Plug is in use.
