Note:
If the following warning appears on the display, the water
tank must topped up before the next drink is dispensed.
Otherwise further function is not possible.
Before inserting the water tank, make sure that it is dry
on the outside. Wipe the water tank shaft dry also before
inserting the water tank.
Filling the coffee bean container:
- Fold back the lid of the coffee container (K).
- Fill the container with fresh coffee beans.
- Then close the container again.
Use:
- Connect the appliance to the mains.
- Turn the appliance on, by pressing the on/off button
and holding it down briefly. During the heating procedure
(approx. 30 seconds) the following display flashes.
- When the operating temperature has been reached,
the coffee machine automatically performs a rising cycle.
Water may flow here into the drip tray.
-When the rising cycle is completed, the coffee machine
is ready to use. The following displays light up during
initial start-up:
Determining the water hardness
Before using the coffee machine for the first time, it
should be set to the appropriate water hardness for
your region. You can determine the water hardness with
the help of the test strip (18) supplied with the coffee
machine.
Proceed as follows:
- Dip the test strip into cold water for 1 second and shake
off the excess water. After approximately 1 minute, the
water hardness can read from the pink-coloured areas.
Menu settings
The menu function must be accessed to undertake va-
rious settings – for example, to set the determined water
hardness level.
To do this, press buttons 2 and 3 simultaneously for
approx. 3 seconds.
The symbol display will briefly light up as a blinking line,
then the display will change to the current settings. The
following parameters can be set:
• Water tank illumination via button 2
• Water hardness level via button 3
• Coffee temperature via button 4
• Switch-off time via button 5.
• Save the entries and quit the menu by confirming with
OK (button 6). If you do not press OK, the program will
automatically return to the operating mode after approx.
60 sec. without saving the new settings.
Setting and storing the water hardness:
- Switch to the menu function by simultaneously pressing
buttons 2 and 3 for approx. 3 seconds. The function
displays of the menu will flash first in a blinking line, then
the current settings will be displayed.
Then press key 3 repeatedly until the required hardness
degree is set.
The image below shows the displays for the 4 possible
hardness degree settings.
Store the input by pressing “OK” (button 6). All function
displays of the menu flash for approx. 3 seconds to con
-
firm. The appliance then returns to the normal operating
mode.
