miniDSP Ltd – Hong Kong /
www.minidsp.com
/ Features and specifications subject to change without prior notice
34
6.3
I
NFRARED REMOTE CONTROL
Many standard and programmable remote control units can
be used with the Dirac Series processor. By default, the
processor recognizes the Apple Remote, with the key
assignments shown at right.
(The commands Config Inc and Source Inc cycle through the
presets and input sources. For example, if the currently
selected preset is 1, pressing Config Inc changes it to 2.
Note that switching between presets takes a few seconds.)
In addition, the processor can “learn” the control codes of your current remote if it supports one of the
following remote control codes:
NEC
Sony
Philips RC6
To initiate the learning process, run the DDRC-22 utility and click Connect. Click on the Learn button for an
operation, and then press the desired button on the remote control. If the code is accepted, a dialog will appear
to show that the code was recognized the status will change to show a tick. If the processor does not recognize
the remote control code, then it will time out and display a message saying that IR learning failed.
Once programmed, check that the programmed buttons perform the expected function.
To "unlearn" a command, press the Learn button and wait for the plugin to time out.
To restore the default Apple remote commands, “unlearn” those commands.
