QUICK START GUIDE
2
4. PX Serial LEDs
LED
Color
Indication
PWR 1
Red
On: Power 1 is on and booting up.
Blinking: Indicates an IP conflict, or DHCP or BOOTP server did not respond
properly.
Green
On: Power is on and functioning normally.
Blinking: Located by Administrator’s Location function.
Off
Power is off, or power error condition exists.
PWR 2
Red
On: Power 2 is on and booting up.
Blinking: Indicates an IP conflict, or DHCP or BOOTP server did not respond
properly
Green
On: Power 2 is on and functioning normally.
Blinking: Located by Administrator’s Location function.
Off
Power is off, or power error condition exists.
Eth 1
Orange
Blinking: 10 Mbps Ethernet connection.
Green
Blinking: 100 Mbps Ethernet connection.
Off
Ethernet cable is disconnected, or has a short.
Eth 2
Orange
Blinking: 10 Mbps Ethernet connection.
Green
Blinking: 100 Mbps Ethernet connection.
Off
Ethernet cable is disconnected, or has a short.
Serial
Orange
Serial port is receiving data.
Green
Serial port is transmitting data.
Off
No data is being transmitted or received through the serial port.
5. Connecting the PX Serial
Connect the PX Serial to the power supply, the Network switch and Serial device as
explained below.
5.1
Connecting the Power supply
You can connect the PX Serial to the Power supply using the Terminal Block
(PWR1) and/or the Power Jack (PWR2). If both power inputs are connected, the PX
Serial is powered from the highest connected voltage. The PX Serial will only send a
loss of power alarm when power fails at both PWR1 and PWR2.
