Minelab Manticore, Instruction Manual

Page: 67 / 78

CONTENTS
67
General Troubleshooting
Try the recommended actions listed, in order, before contacting an Authorised Service Centre�
Detector does not turn On, or turns Off by itself (with or without a Critically Low Battery Error Message)
1. Check that the Coil is connected�
2. Charge the detector�
3. Check that the detector is charging and the green Charge Status LED is flashing�
4. Check that you are charging from a USB charging source with a 2 A @ 5 V charging capacity�
5. Check that the magnetic connector and Charging Interface on the back of the Control Pod are clean and free of debris�
6. Check that the USB charging cable is properly seated/connected to the detector�
Erratic/excessive noise
1. Move away from local sources of Electromagnetic Interference (EMI)�
2. Perform an Auto Noise Cancel�
3. Perform a Ground Balance�
4. Reduce the Sensitivity Level�
No sound – Wired headphones
1.
Check that the detector is On, and start‑up has completed�
2. Check that the headphones are plugged in and fully inserted into the Headphone Socket�
3. Check that the Headphones Connection icon ( ) is displayed in the Status Bar�
4.
Check that Volume is set to an audible level�
5.
Unplug the headphones and confirm that the detector Speaker is audible�
6.
Check that the headphones connector is free of moisture or debris�
7.
If available, try using a different set of headphones�
No sound – ML 105 wireless headphones
1. Check that the headphones are turned On�
2. Check that detector Wireless Audio is turned on and paired with headphones (i�e� the Wireless icon is steady on)�
3. Check that the headphones are charged�
4. Check that the detector Volume is set to an audible level�
5. Check that the volume control on the headphones is set to an audible level�
6. Pair the detector to a different set of compatible wireless headphones�
7. Try wired headphones�
ML 105 wireless headphones will not pair
1. Try powering off the ML 105 headphones and then re‑pair�
2. Ensure the headphones are within 1 metre (3 feet) of the detector Control Pod, with no obstructions between the
headphones and detector (including your own body)�
3. Move away from sources of interference such as mobile phones�
4. If there are many other Bluetooth or Wireless devices nearby, pairing may take longer� Move away from the area and try
to pair again�
5. Factory Reset the headphones and attempt to re‑pair to the detector�
6. Pair the detector to a different pair of compatible wireless headphones, then attempt to re‑pair the original
headphones to the detector�
Distortion/crackling heard in ML 105 headphones when connected via wireless audio.
1. Ensure the headphones are within 1 metre (3 feet) of the detector Control Pod, with no obstructions between the
headphones and detector (including your own body)�