Minebea Intec IFXS4, Installation Instructions And Safety Information

Page: 7 / 104

6 Bedienungsanleitung IUXS4
Bedienungsanleitung IUXS4 7
§
Adjust the gap as needed.
If necessary, loosen the bolts that
attach the downholder.
Bolt size: M8; wrench size: 13.
§
Before the scale platform can be
raised to a vertical position, loosen the
stop bolts on the right and left.
!
Danger of damage to the stop
bolts! The rear stop bolts must be
disengaged!
§
Grasp the platform by the handles and
raise it to the vertical position.
Note:
Two persons are required for raising
the platform.
!
Please observe the safety instructions,
as there is a hazard of personal injury.
Always wear safety gloves while rais-
ing or lowering the
platform.
!
Warning: Danger of personal injury!
Do not stand or move beneath the
platform.
§
Turn the left and right stop bolts.
The bolts slide into the side plate and
secure the platform in the vertical
position.
$
The surface under the platform
can now be cleaned easily.
§
Install the pneumatic springs
(right and left) as shown in the
illustration.
Tighten the bolts (size M10;
wrench size: 17).
§
Following installation, return the
platform to the horizontal position.
§
Turn the rear stop bolts (right and
left). The bolts slide out of the side
plate and release the platform.
!
Danger of damage to the stop bolts!
The stop bolts must be disengaged!
§
Grasp the platform by the handles
and lower it to the horizontal
position.
Note:
Two persons are required for
lowering the platform!
!
Please observe the safety instruc-
tions, as there is a hazard of personal
injury. Always wear safety gloves
while raising or lowering the platform.
Do not stand or move beneath the
platform.
§
The platform is now in the horizontal
position.
§
Place your foot on the right-hand
downholder to press the side plate
of the scale to the floor; repeat
this procedure on the left-hand side
as well.
§
Position the front stop bolts (right
and left) to fix the scale in position
and turn the lever.
§
Remove the right and left mounting
aids as follows:
Unscrew the four M8 bolts as shown
(wrench size: 13).
§
Hook the drive-on ramp onto the
right and left retainers.