Mindray uMEC10, Service Manual

Page: 12 / 32

5. 5. Select Select [[ Main Menu Main Menu ] → [ ] → [ Maintenance >> Maintenance >> ] → [ ] → [ User Maintenance >> User Maintenance >> ] → [ ] → [ Module Module
Maintenance >> Maintenance >> ] → [ ] → [ Cal. IBP Press. >> Cal. IBP Press. >> ]. In the [ ]. In the [ Cal. IBP Press. Cal. IBP Press. ] menu, set the ] menu, set the
calibration value to 200 mmHg. calibration value to 200 mmHg.
6. 6. Select Select the the [[ Calibrate Calibrate ] button next to the ] button next to the desired IBP channel to start a calibration. desired IBP channel to start a calibration.
7. 7. The The message message [[ Calibration Completed! Calibration Completed! ]] is displayed after a successful calibration. is displayed after a successful calibration.
Otherwise, a corresponding message will be Otherwise, a corresponding message will be displayed. displayed.
Method 2: Method 2:
Tools required: Tools required:
 
Standard s Standard sphygmomanom phygmomanometer eter
 
Balloon pump Balloon pump
 
Tubing Tubing
 
T-shape connector T-shape connector
1. 1. Connect Connect the the 3-way 3-way stopcock, stopcock, the the sphygmomanomete sphygmomanometer a r and the nd the balloon balloon pump pump through through aa
T-shape connector, as shown below. T-shape connector, as shown below.
2. 2. Turn on Turn on the 3-way the 3-way stopcock to stopcock to the air the air to zero to zero the trans the transducer, a ducer, and then nd then open the open the stopcock stopcock
to the to the sphygmomanometer sphygmomanometer..
3. 3. Select Select [[
Main Menu Main Menu
] → [ ] → [
Maintenance >> Maintenance >>
] → [ ] → [
User Maintenance >> User Maintenance >>
] → [ ] → [
Module Module
Maintenance >> Maintenance >> ] → [ ] → [ Cal. IBP Press. >> Cal. IBP Press. >> ]. In the [ ]. In the [ Cal. IBP Press. Cal. IBP Press. ] menu, set the target ] menu, set the target
pressure calibrati pressure calibration value of the target c on value of the target channel. hannel.
4. 4. Inflate Inflate using the using the balloon balloon pump pump until the until the reading reading of sphy of sphygmomanometer gmomanometer approximates approximates
the preset calibration value. the preset calibration value.
5. 5. Adjust Adjust the the calibration calibration value value in in the the [[
Maintain IBP Maintain IBP
] menu until it is ] menu until it is equal to the reading equal to the reading
of sphygmomanometer of sphygmomanometer
6. 6. Select Select the the [[ Calibrate Calibrate ] button next to the ] button next to the desired IBP channel to start a calibration. desired IBP channel to start a calibration.
Sphygmomanometer Sphygmomanometer
T-shape connector T-shape connector
3-way stopcock 3-way stopcock
Pressure transducer Pressure transducer
Pressure adapter cable Pressure adapter cable
IBP module IBP module