83
17 Quick setting to point or distributed coordination wireless network
The steps of setting are:
1.
Both the handheld unit and the cradle are in normal working mode. Normally it means that only the
blue LED on the handheld unit and only the blue LED on the cradle are ON as shown below.
The scanner offers two kinds of wireless network topology: point coordination and distributed
coordination. Note that the current applied wireless network topology of the handheld unit or the
cradle does NOT make any difference in the following setting.
2.
Scan ONE of the following setting barcodes. Other radio parameters include channel no., address,
etc.
Set to point coordination network without changing other radio parameters
Set to distributed coordination network without changing other radio parameters
Set to point coordination network with returning default radio parameters
Set to distributed coordination network with returning default radio parameters
3.
The blue LED on the handheld unit will blink and the beeper will beep regularly to indicate that the
handheld unit is ready to be positioned onto the cradle.
4.
Firmly position the handheld unit onto the cradle within 15 seconds. A long beep and a short beep
will be emitted to indicate a successful setting; otherwise, three short beeps will be emitted to
indicate an unsuccessful setting.
5.
Referring to the previous chapter of “display firmware version & radio communication setting”, check
the current radio communication setting of the handheld unit and the cradle.
Summary of Contents for CS3290
