MIMAKI JV400-130LX, Installation Manual

Page: 30 / 50

© 2014 MIMAKI ENGINEERING CO.,LTD. 5.1 P.5
5.1 Changing the Joints
R.1.1
1
2
3
4
5
6
7
□
When white ink is used, connect the ink tube of circulation path (circulation tube) in accordance with the
following.
1. Remove the Damper rubber cap ( x2).
2. Connect two Circulation tubes as shown in the left figure.
Connect the left Liquid contact valve to the right-upper joint of
the damper.
Connect the right Liquid contact valve to the left-lower joint of
the damper.
(When you look down the tubes, tubes are crossed.)
□
When white ink is used, connect the tube for white ink filter in accordance with the following.
1. Remove Rear cover - LU LX from the back panel of the main
unit.
2. Connect the part of the red dotted line of the figure below.
(Remove the No.7 and No.8 filter.)
3. Return the Rear cover - LU to the original location, and affix
using the screws.
Remove rubber cap
From left-lower
joint of damper
From right-upper
joint of damper
P
Remove
W filter
W filter tube with
Extension tube
Attach the
Fitting
Check valve
Pump
In
k sup
ply
Tube tag “8”
Tube tag “7”
Extension tube
W filter
L connector
No.7, 8
INSTALLATION GUIDE > Ink Set > Changing the Joints
Model JV400-130/160LX Issued 2013.10.10 Revised 2014.04.30
F/W ver.
2.50
Remark
1.1
Rev.