Milwaukee M18 FDEX, Operator'S Manual

Page: 5 / 8

5
Switching sides for the Depth Gauge
4.
1. Turn OFF the tool.
2. Remove the battery pack.
3. Remove the depth stop (see "Removing/Installing
the Depth Stop").
5.
6.
7.
Remove the screw attaching the front depth brack-
et to the ruler assembly with a philips screwdriver.
the bottom plate of the ruler assembly out of the
front button, this may require both buttons to be
pushed at the same time.
Remove the rear depth bracket from the ruler as-
sembly and reassemble it so the bracket hangs
on the desired side.
Slide the bottom ruler plate through the top button
(the reverse of step 5).
8. Reattach the bit depth gauge button, the top
small tabs.
9. Install the depth stop (see "Removing/Installing
the Depth Stop").
Attaching the HAMMERVAC™ to the
Rotary Hammer
These HAMMERVAC™ Dust Extractors are for use
with dedicated rotary hammers. Refer to the Speci-
1. Remove the battery pack from the rotary hammer.
2. Slide the foot of the rotary hammer onto the dust
extractor.
3. Push the contacts through the protective cover
on the rotary hammer. The hammer release will
snap into place.
Installing/Removing the Bit
Fitting the HAMMERVAC™
to the Tool and Bit
Correct
Incorrect
Incorrect
depth gauge button.
For proper suction and depth
control, position the nozzle as-
forward face of the nozzle:
1. Press and hold the tool and bit
2. Push in the nozzle assembly
front face of the nozzle.
3. Release the tool and bit depth
gauge button.
N O T E : F u l l y e x t e n d t h e
HAMMERVAC™ before storing
to preserve spring life.
Setting the Drilling Depth
1. Fit the HAMMERVAC™ to the tool and bit.
2. Press and hold the depth gauge button and slide
the depth gauge to the desired depth. The drilling
depth is the last visible measurement shown when
viewed from the depth gauge on the top of the
tool. To ensure the HAMMERVAC™ is properly
set to the tool, bit, and desired depth, always drill
a test hole.
Depth Drill
NOTE: When using the optional Crevice Tool
(Cat. No. 49902325), set the drill depth to 0.
Slide the bit through the nozzle and then install into
the tool according to the tool manufacturer's
instructions. For best results, use a bit 203 mm (8")
in length or shorter for M18 FDEX and use a bit
254 mm (10") in length or shorter for M18 FPDEX.