FUNCTIONAL DESCRIPTION
1. Jacket
and Pocket
Power Buttons
High: Red LED
Medium: White LED
Low: Blue LED
2
1
3
OUT
DC OUT
IN
4
5
6
7
9
10
SYMBOLOGY
ASSEMBLY
2. Power Cable
3. Battery Controller Pocket
4. USB out
-
WARNING
Recharge only with the charger
Volts
Direct Current
Machine wash, gentle cycle in warm water
Do not bleach
Do not wring or twist
Tumble dry, low heat
Do not iron
Do not dry-clean
Regulatory Compliance Mark (RCM).
This product meets applicable regulatory
requirements.
3
manual supplied with your charger and battery.
Inserting/Removing the Battery
To
insert
the battery, slide the pack into the body of
the battery controller. Make sure it latches securely
into place.
Insert the power cable (from inside the battery
controller pocket) into the power cable port on the
battery controller.
Using the USB Out Port
The USB port can be used to charge a cell phone,
MP3 player, or other personal device that uses less
than 5V, 2.1A of DC electrical current. The cord can
be run from the battery controller pocket, through the
grommet and channel on the interior of the jacket,
and through another grommet into a side pocket. It
is not recommend to use the pocket warmer when
an electronic device is charging in a pocket.
Fuel Gauge
OPERATION
The zone power buttons are located on the upper left
side of the jacket. Use the jacket
and pocket
power buttons to control the two zones.
To
remove
the battery, push in the release buttons
and pull the battery pack away out of controller.
To
turn on
, press and hold (1 to 2 seconds) the
desired zone's power button. The desired zone will
turn on to High and the red LED will illuminate.
Temperature setting can be adjusted at any time by
pressing the specific zone's power button. Each
press will cycle through the selected zone's
temperature settings. To turn off the heated jacket,
press and hold (1 to 2 seconds) each of the zone’s
power buttons. The LED(s) will turn off. If the
heated jacket turns off unexpectedly, check
connections and charge the battery pack.
8
5. Fuel Gauge LEDs
6. USB power button
7. Micro USB in
9. DC out
10. Battery port
8.Charging LEDs
RED: Charging
Green: Charging
complete
Press the USB power button to display the battery
pack’s remaining power on the fuel gauge LEDs.
T3.0A
Read Operator's Manual
Class III appliance
Time-lag fuse 3.0A
This charger was only suitable for indoor
use. Never expose the charger to rain.
Place the battery controller into the pocket and zip
closed. Use the smaller rear section of the pocket
to hold smaller M12™ batteries and if necessary
the front section of the pocket which can accommo-
date larger battery packs.
CARE
WARNING
To reduce the risk of injury, always
-
If the heated jacket does not start or operate properly
with a fully charged battery pack, clean the contacts
on the battery pack. If the heated jacket still does
not work properly, return the heated jacket, charger
and battery pack, to a
service facility
for repairs.
To turn on the USB Out Port, press the USB power
button. The USB Out Port will remain on for two
hours before turning off automatically.