7
PAGE
4939 5258 01
Disassembling
the armature
1
Loosen three Allen screws (8) from the
bearing end plate (7) and pull the
complete armature assembly (B) with
the bearing end plate (7) from the
gear box (1).
2
Remove the seal (2) from the gear box (1).
3
Insert the pin-type face spanner (service
tool) (3) into the seal ring (4) and remove
the seal ring (4) counter-clockwise.
Remove the bearing end plate (7).
4
Remove the locking ring (5) from the
bearing end plate (7) and press out the
bearing (6).
5
Separate the fan (9) from the armature (B)
with the forcing discs (A).
6
Remove the rubber sleeve (D) and press
off the bearing (C).
Detaching the
crank wheel
1
Remove the following parts from the gear
box (4):
– crank wheel (5)
– disc (8)
– axial bearing (9)
– disc (B).
2
Pull the needle bearings (6) and (7) with
the interior extractor (A) from the crank
wheel (5).
3
Combined drill/chisel hammer:
Additionally remove the safety clutch (1)
from the gear box (4). Pull the needle
bearings (2) and (3) with the interior
extractor (A) from the gear box (4).
☞
The chisel hammer does not have
a safety clutch (1) and needle bear-
ings (2) and (3)!
9
2
3
4
5
6
8
7
A
B
C
D
1
13
1
2
3
4
5
6
7
9
B
A
8
14
