Milnor MWF125J7, Manual, Page: 77 / 112

Page (2 / 5)
PELLERIN MILNOR CORPORATION
Figure 2: Adjust Door Position
Adjust Door Position
Install door with all shims
and hardware. Do not
tighten bolts.
1. Make sure the door
channel is level.
2. Test that the door is
centered to the door
opening.
3. Check door position.
Apply chalk around the
knife edge ring. Close the
door and activate the door
seal. Open the door and
check the impression on
the door gasket. The chalk
5. Recheck door position.
impression should be centered on the door gasket and a continuous circle.
4. Adjust the position of the whole door. For left/right adjustments, slightly loosen the bolts shown
circled above and adjust door with a rubber or leather mallet. For vertical adjustment, slightly
loosen hinge bolts and adjust door.
6. When the door is centered, adjust the door striker to match the door. It should have the same gap
top and bottom.
centered and
on gasket.
should be
continuous
Chalk ring
Make a
chalk ring
around
knife edge.
A
B
A
B
Level
Manual Door
MWF100C7, MWF100Y7, MWF100J7, MWF100Z7; MWF125C7, MWF125Y7, MWF125J7, MWF125Z7
BMP180039/2021305A
73