Milnor MWF125J7, Manual, Page: 50 / 112

Pellerin Milnor Corporation
3. Tighten the bolt to the value shown in the correct table ( Threadlocker by the Diameter of the
Bolt (see below Note ) This topic can be found in Milnor document elsewhere to Torque Val-
ues for Stainless Steel Fasteners 5/16-inch and Smaller This topic can be found in Milnor
document elsewhere
).
Figure 3. Apply Threadlocker in a Through Hole
Application
Legend
A... No threadlocker here
B... Apply the threadlocker to this area
X... Nut depth
3.3. Disassembly
BNUUUN02.C07 0000222444 A.3 B.3 11/26/19 2:59 PM Released
For high-strength threadlocker, apply heat for five minutes. Disassemble with hand tools while
the parts are hot.
For low-strength and moderate-strength threadlocker, disassemble with hand tools.
Figure 4. Use heat for disassembly of fasteners with threadlocker.
Apply Heat to a Small Area
Legend
A... How to apply heat to a small fastener
B... How to apply heat to a large fastener
End of document: BNUUUN02
Torque Requirements for Fasteners
46