11 of 32
Retrieve the x/z assembly. The v-wheels will pinch the outside
of the Mega V extrusion using the v shaped slots on the top and
bottom. If the v-wheels are too tight to slide on the extrusion,
use a 10mm wrench to turn the eccentrics until the assembly
slides onto the extrusion.
Slide (6) large t nuts into the bottom slot of the Mega V
extrusion.
Retrieve the left end plate. On the left side of the extrusion, use
5/16 x 3/4 button cap screws to attach the left end plate to the
extrusion. Repeat the process on the right side with the right
end plate.
Tilt the gantry forward to gain access to the bottom. Using (6)
M5x12 button cap with M5 split-lock washers and the already
installed large t nuts, attach (2) drag chain supports. The drag
chain supports need to be positioned on the right side of the
gantry as seen from the front with the slotted ends pointed out
towards the end plates. Leave loose. Please be careful not to
bend the drag chain mounts. Set the gantry to the side.
