22 of 32
When all is adjusted, fasten the Y end plates to the legs using drop in T
nuts and M5x12 button cap screws. Place the drop in T nuts into the
legs, then push them up to the holes using a zip tie (from the wire
management bag), a screwdriver, or something similar.
Place the M5x12 button cap screws through the holes and tighten the Y
End Plate to the leg by fastening into the Drop-in T Nuts.
Pinion Gear and Motor Installation
Parts
Motors, Length 3675 (2)
Motors, Length 2550 (1)
Pinion Gear Set (Contains 3 pinion gears and 6 set screws)
Hardware
M4x16 Machine Screws (10)
M4 Nylock Nuts (10)
Tools
2.5mm Hex Key
Needle Nose Pliers
Philips Head Screwdriver
Slide a pinion gear over each motor shaft and install the set screws that
come in the pinion gear bag. Notice that the motor shafts all have a flat
side.
Be sure that one of the set screws is on the flat portion of the
motor shaft. The pinion gear should be installed almost all the way
down the shaft. If you don
’
t place it far enough down the shaft, the
top of the gear will drag on the Y extrusion when installed.
