28 of 32
Attach the Z switch wires onto the Z axis homing switch. The Z
uses the connector with just a single wire pair and is the longest
wire set in the homing switch. The black wire goes onto the
terminal on the side while the red wire goes onto the bottom
terminal nearest to where the black wire is installed.
Use needle nose pliers to slide the connector onto the terminal. If
for some reason you must slide it back off, pull it by the connector
and not by the wire.
Begin running the wire through the X drag chain. The router wire,
X motor wire, Z motor wire, and Z switch wire will run through this
drag chain.
Leave a couple of the cover pieces unclipped on the end of the
drag chain to make it easier for the wires to enter the chain. Keep
in mind that you can snap the drag chain apart and back together
if it makes it easier for you to run your wires.
